ROD & END CAP SETS:
All Rods come with caps on both ends. Rods are a minimum of 13 inches long and can be up to 14 inches in length and are approximately 1/8 inch in diameter. The rods fit through the 6x9mm pony beads. They do not fit through the mini pony beads (see below). The end caps are removable so that you can cut the rod to a shorter length, however they do not fall off easily and will stay on a completed banner.
SPECIAL ORDER RODS:
If you need rods cut to a certain length I can do that for you. The price will be the same. Just order the number of rods that you want and then EMAIL ME immediately at fyremonksgal@msn.com what size you want them cut to. They can be cut in any combination (for instance 5 at 7 inches and 5 at 11 inches OR 3 at one size, 3 at another, and 4 at another). Just be specific in your email. DO NOT PUT YOUR MESSAGE IN PAYPAL.....for some reason we do not always get those messages.
SMALLER RODS:
I have a limited amount of rods that are thinner than the usual ones and will fit in the mini pony beads. They will have a little bit different looking end cap on it because the ones pictured will not stay on them. If you want the thinner rods, email me FIRST at fyremonksgal@msn.com and tell me you want the smaller ones and I will see if I have any in stock available. DO NOT ORDER and then ask me because you will get the larger diameter rods if I don't have any of the thinner ones in stock.
END CAPS:
The inside diameter of the end caps are 1/8".
|