Basic Earring Head Pin Wiring
Note: Head pins look like over sized sewing pins and come in different sizes and lengths your pin needs to be at least 3/4 inch longer than the beads you will be using.
You will need: Round noise pliers, standard needle noes pliers,Beads and head pins.

Step 1 Start by flat bending wire above last bead. Step 2: Using Round Noes Pliers hook wrap wire around noes. The higher up the pliers the larger loop you will make. Loop round until you touch back to wire.

Step 3: While still wrapped around Round-nose pliers use needle nose pliers to wrap around wire between loop and beads. You can attach your finding by keeping its opening in the loop before you twist or use a jump ring to make the connection.

Link Wiring is even easier

NOTE: Eye pins already come with one side done. Step 1: place bead or beads on wire to desighn your link. then fold wire over at 45 degrees trim wire leaving enough for the loop and with Round-nose pliers compleet the loop. Note the tip of the wire should head back to hole to make beads tight on the wire.