|
|
Printed Vinyl Sticker Installation Instructions
& Removal |
|
[ Please Read Carefully ] |
 |
|
Application Surface Temperature should be between 60°F [15.5°C] and 90°F Degrees [32°C], with 70°F [21°C] to 80°F Degrees [26.5°C] being the Ideal Range |
|
Application Surface MUST BE Completely Clean and free of any Dust, Oils, Wax or other Debris and Completely Dry before Installation. If you're Applying the Sticker to Glass, We Recommend using Isopropyl Rubbing Alcohol to Clean the area the Sticker is being Applied to. If you are using Windex or another Ammonia-Based Cleaner to Clean the Surface, Dry the area Completely before Applying the Sticker; the Ammonia may interfere with the Adhesive. Any Surface Contamination such as Bad Bodywork, Rust, Dust or other Debris will show through and Spoil your Final Result |
|
Do not Apply in Rain or Direct Sunlight |
 |
|
Thoroughly Clean and Dry the desired surface, Peel the Sticker from the Backing Paper and Stick to the Desired Surface |
 |
|
• After Application, do not wash your Vehicle for at least 1 Week to allow the Adhesive to set and ensure proper Adhesion |
|
• Always Clean your Sticker with a Non Abrasive Cleaner |
|
• Take care when Waxing your Vehicle. Wax buildup around your Sticker may cause the Edges of the Sticker to Lift |
|
• Never hold a High Pressure Washer Nozzle or Heat Gun close to or Directly on your Sticker for Longer than a Few Seconds |
|
• If your Sticker is Applied to Glass and you Need to Use an Ice Scraper, Scrape and Clear the Glass around your Sticker. Never Scrape over the Sticker. It may cause the Edges or your Sticker to Lift |
 |
|
On Glass Surfaces: Use a Single Edge Razor Blade to Remove the Sticker. It is best to do this when Temperatures are between 70°F [21°C] and 80°F [26.5°C] Degrees |
|
On Painted Surfaces: Use a Heat Gun or Hair Dryer to Warm the Sticker until it Peels off Easily |
|
All Adhesion or Installation Related Problems are assumed to be the fault of Improper Conditions or other Installer Related Error. We will not Refund Payment for a Sticker that does not Install Properly |
| |
|
All Content and Information
on this page is Intellectual Property of Rotten Remains and Protected under
Copyright Laws. Copyright © 2009 Rotten Remains All
Rights Reserved |
) 
