Bread Crumb Link
We are on vacation from 29th, Jan to Sep to 8th, Feb.
But We will check your question and message, so if you want to ask something please contact me.
Thank you so much.
May your family be blessed with good health and happiness.
Have a lovely day!

Store search

Store pages

Store Newsletter!
Add my Store to your Favorites and receive my email newsletters about new items and special promotions!
General Interest
제목 없음



Add to Saved sellers

WALL STICKERS (Peel & Stick)

Step1. The surface on which you are applying the sticker should be a smooth surface free of dust or oily matter.
Step 2. Position the sticker without applying pressure to get an idea of the effect they create. Reposition them if necessary.
Step 3. Fix the sticker from the top downwards, and from center to the edges, using soft cloth or credit card.



Step 1. Clean the area you are going to apply the sticker to throughly (note: Do not use windex or any other ammonia type cleaner, soap and warm water will do fine)

Each decal is made up of 3 Layers :

The top layer is transfer tape just like masking tape.
The middle layer is your vinyl decal.
The bottom layer is the paper backing.

Step 2. Take the transfer film out. Put transfer film on top of graphic sticker.

Step 3. Rub top transfer film with soft sloth or towel.

Step 4. Measure and mark your location first before removing the paper backing from the sticker. and Cut out images

Step 5. Place the adhesive side down against the chosen surface and using a credit card or something similar, rub the surface thoroughly working any bubbles toward the edge.

Step 6. After a couple of minutes you can remove the application tape by pulling it straight back, be sure that the graphic has stayed on the surface and not the tape.

Step 7. If you see any bubbles you can use a small sewing pin or thumb tack to poke a tiny hole and then push the bubble out of the graphic with your finger.


Copyright © 2010 Dreamingidesign. All Rights Reserved.